Page 1 of 1

Fusible Link

PostPosted: Tue Dec 02, 2014 11:00 pm
by EH_Wagon179

Does the original wiring harness have a FL at the starter solenoid?

I cannot see one on the wiring diagram, or on my EH.

Currently have motor out for rebuild. Will consider a FL or maxi fuse if there's nothing in place.

Also, does anyone know what gauge wire is used from factory for Alternator B+ stud to battery? I'm assuming it's pretty thin! I don't have any large acc loads other than thermo fan, but will look at upgrading this also. I have 80 amp alternator and AGM battery, so battery will accept a fair current load if low.